• If you're struggling to login because of the verification email not reaching you, don't worry it's just the forum settings applying the change slowly. I'll get in touch with those who are awaiting the verification email and sort your accounts out. I think new ones should go through fine now in most cases.

Feeds from PlumbersTalk.net

Post thread
Normal Threads
S
PT: Capped gas pipe begging oven
PT: Capped gas pipe begging oven Hi all. Hope you are well. So I fitted a new induction hob today for my father and whilst the old hob was off I saw that the old gas pipe for an old gas hob that has been capped off with a solder fixing is touching the back of the oven housing. I pulled that...
Replies
0
Views
59
Steveuk
S
G
PT: Replacing push fit Osma Gold for something else - tap change
PT: Replacing push fit Osma Gold for something else - tap change Hi, I know the fittings I have are Wavin Osma Gold and have done a fair bit of research into them, I just wanted to confirm once I try and demount the fitting with bent circlip pliers and discard the Osma, as long as I keep the...
Replies
0
Views
59
Gs2022
G
T
PT: Ideal logic C35+ with Halo Lite RF ( not wi-fi)
PT: Ideal logic C35+ with Halo Lite RF ( not wi-fi) Trying to find an answer to my question regarding "load compensation" Once Halo target temp of 20*c is reached , + another 5* (20'5*c) and the red flame in the display and green "demand" light on the reciever go out, the boiler still kicks in...
Replies
0
Views
56
trickytrev
T
J
PT: Is that right to add inhibitor in boiler filter?
PT: Is that right to add inhibitor in boiler filter? I had an engineer today added inhibitor in the boiler filter via Magnaclean when he did the boiler service after taking off the filter. But before the engineers all added inhibitor in the radiators, and I searched online that majority...
Replies
0
Views
66
Jurgenjay
J
M
PT: Sentinel x800
PT: Sentinel x800 If putting this in a system would it at all help clean a plate heat exchanger if repeatedly turning the hot tap on so the C/H water runs through the plate? I imagine not or everyone would so it instead of taking the plate out. Thanks PlumbersTalk: Sentinel x800 to Continue...
Replies
0
Views
83
Matt0029
M
B
PT: Is there a stand alone multiroom controller for wireless TRVs?
PT: Is there a stand alone multiroom controller for wireless TRVs? Hi, can anyone recommend a controller for wireless TRVs that can set on off time for individual TRV using a phsical control panel with it's own interface/screen that does not need a smartphone app to work and can be used stand...
Replies
0
Views
58
bureaucrazy
B
B
PT: WANTED: Grasslin Famoso 601rf timer thermostat
PT: WANTED: Grasslin Famoso 601rf timer thermostat Hello, the clock broke on my wireless mechanical timer thermostat for my baxi boiler. The item is 20 years old now so someone might have a spare one from removing an old boiler. The Grasslin famoso 601rf was supplied for several brands but its...
Replies
0
Views
62
bureaucrazy
B
B
PT: Draining radiator?
PT: Draining radiator? I’ve got this radiator that I need to drain down & remove to clean out due to sludge. Can I drain it with that drain valve on the left because as you can see that it connects to the radiator but that pipe also runs along past the radiator on the right? PlumbersTalk...
Replies
0
Views
87
ben100
B
G
PT: Radiator flex pipes
PT: Radiator flex pipes Could I pull these flex pipes up by cable tying them onto the back of the radiator (it’s a double rad) Just wondering if the heat against the cable ties would be ok. I’ve seen the cable clips you can get but not much room for them. Any help appreciated PlumbersTalk...
Replies
0
Views
67
Glasgowman
G
M
PT: What is causing water hammer in my flat?
PT: What is causing water hammer in my flat? Hello I wonder can anyone shed any light on what is becoming an annoying problem? I had a new stopcock installed in my second floor flat a year ago. This was intended to stop water hammer which had been taking place. However, recently the water...
Replies
0
Views
60
Mr Gwent
M
H
PT: Boiler Programmer
PT: Boiler Programmer I have a wall mounted thermostat which is connected to a 26 volt supply from my Glowworm 24ci boiler. I would like to replace this thermostat with a programmer so i can time when the heating comes on and off. Currently the heating is turned on/off using the thermostat. Can...
Replies
0
Views
59
homebrewer55
H
D
PT: Issues With Nest Generation 3 Operating Boiler?
PT: Issues With Nest Generation 3 Operating Boiler? I have a Google Nest Generation 3 Thermostat/Heatlink, Thermostat is in the hallway and operates non hard wired, Heatlink is upstairs in the airing cupboard. There is also a Mains Link fitted for the boiler over run. I have an intermitant...
Replies
0
Views
61
Dulbert
D
G
PT: Apprenticeship Portfolio
PT: Apprenticeship Portfolio About to complete my plumbing and heating apprenticeship. Portfolio complete and signed by employer who has grandfather rights in plumbing but is gas safe registered. Tutor now informs me that my employer may not be qualified to sign off on my plumbing section of my...
Replies
0
Views
75
Ghostrider
G
I
PT: Riello rdb 1 brandnew retro fitted to a firebird 70-90
PT: Riello rdb 1 brandnew retro fitted to a firebird 70-90 Fitted a new riello 1 rdb the noz zle that came with it was a .6 80 eh but no settings in the manual what it should be?? I got the CO2 at 11.6 Oil pressure 100 Any advice? PlumbersTalk: Riello rdb 1 brandnew retro fitted to a firebird...
Replies
0
Views
140
Inverness
I
T
PT: How do I remove the front cover from a Vent Axia extractor fan
PT: How do I remove the front cover from a Vent Axia extractor fan The model number is not shown, but I have attached an image of the model. There are two small flexible plastic tabs underneath the fan. I have tried squeezing them together. They click but they don't release the front cover. I...
Replies
0
Views
79
talktalk
T

Latest Topics

Back
Top