• If you're struggling to login because of the verification email not reaching you, don't worry it's just the forum settings applying the change slowly. I'll get in touch with those who are awaiting the verification email and sort your accounts out. I think new ones should go through fine now in most cases.

EF: Shed feed line

Post thread
Post reply

Currently reading:
EF: Shed feed line

M

MarkS57

Shed feed line

Hi
Here is my scenario. I want to install a 20A 240v service to my shed. Hoping to use a defunct SPA panel left by the PO- a 50A CH50SPA on the side of the house.. Recently, I've had landscaping work done that is between the house & shed and while the landscapers were doing that I had them run a 3/4" SCH40 conduit from the SPA panel to the shed. The 50A service to the SPA panel from the house breaker panel is #6/3 w/ ground. 1st off, I'd like to retain the 6/3 to the SPA panel but replace the 50A breaker in the house panel with a 20A. Outside, I want to remove the SPA panel from the side of the house and replace with an LB body to connect to the conduit. I have 12/3 w/ ground UF to run from the house to the shed where I'll put another another LB to enter the shed. Inside the shed I'll re-install the original SPA panel but with a 20A GFI disconnect in place to the original 50A GFI then run to a small panel for further distribution. I know this will work- question is if I'm running a fowl of any code violations. Thanks, Mark

Shed feed line to Continue reading...

ElectriciansForums.net for the latest in electricians' jobs, news, advice and more
 

Latest Topics

Back
Top